Zhejiang Sehome Home Technology Co.,Ltd
Specialize In Pvc Panels For Domestic and Commercial

Phone:+86-573-87888899

Home > News > Content
How To Lay Welding Of PVC Panels

  How to lay welding of PVC Panels

  PVC Panels is also known as decorative film, adhesive film, used in building materials, packaging, medicine and many other industries. Building materials industry accounted for the largest proportion, 60%, followed by the packaging industry, there are a number of other small-scale applications of the industry.

  PVC Panels should be placed in the construction site for more than 24 hours. The temperature of the plastic plate can be consistent with the indoor temperature to reduce the material deformation caused by the temperature difference. The use of professional trimming machine to PVC Panels at both ends of the stress of the cutting edge. Both sides of the cutting width should not be less than 1 cm PVC plastic sheet laying, at all materials interface should be used overlap cutting. The width of the general overlap shall not be less than 3 cm. According to the different plates should use the corresponding special glue and glue scraper. PVC Panels in the laying, the end of the plate will be rolled up, the back and front of the PVC Panels clean and clean, and then the special glue scraping on the floor. Scrape glue must be even, unfavorable too thick. The effect of using different binders is not the same. Specific products should be referred to the specifications of the use of special glue

  The slotted PVC Panels should be opened after 24 hours. Use a special slotting device to open the groove at the seams of the PVC Panels. In order to weld firmly, the depth of the groove should be 2/3 of the thickness of PVC Panels. Dust and scrap in the tank should be thoroughly removed before welding. Finally, after completion or before the use of PVC Panels to clean. However, the PVC Panels must be laid after 48 hours. PVC Panels After construction should be timely cleaning or vacuuming. The use of neutral detergent is recommended to clean all dirt. If the surface of PVC Panels is dirty, it is recommended to use a washing machine with red grinding plate cleaning.


Products
Contact Us

Zhejiang Sehome Home Technology Co.,Ltd

Add:Nianchang Village, Yuanhua Town, Haining, Zhejiang Province, Jiaxing, Zhejiang, China

Tel:86-573-87888899

Phone:86-13757330052

Fax:86-573-87018910

E-mail:deanxu@cnhaomen.com

Website:www.sehome-pvcpanel.com

View Our Events Calendar

2018

Redstarv

© 2017 | PRIVACY POLICY

Online Support

Tel:+86-573-87888899

E-mail:deanxu@cnhaomen.com

Address: Nianchang Village, Yuanhua Town, Haining, Zhejiang Province, Jiaxing, Zhejiang, China

Get in Touch
Home | About Us | Products | News | Exhibition | Contact Us | Feedback | Mobile | XML